Fujitsu AirStage-H component for ESPHome

An ESPHome component to control Fujitsu AirStage-H (product line previously known as Halcyon) units via the three wire (RWB) bus.

substitutions:
  name: halcyon-controller
  friendly_name: Halcyon Controller
  halcyon_name: My AC
  esp_board: esp32-poe-iso

packages:
  wifi: !include common/wifi.yaml

external_components:
  - source: github://Omniflux/esphome-fujitsu-halcyon
  - source: github://Omniflux/esphome-tzsp

esphome:
  name: ${name}
  friendly_name: ${friendly_name}
  platformio_options:
    build_flags: 
    - -std=gnu++2a
    build_unflags:
    - -std=gnu++11

esp32:
  board: ${esp_board}
  framework:
    type: esp-idf

api:

ota:
  password: !secret ota_password

sensor:
- platform: uptime
  name: "Uptime"
  update_interval: 60s

button:
- platform: restart
  name: Restart device
  entity_category: config 
- platform: safe_mode
  name: Safe Mode Boot
  entity_category: diagnostic

#logger:
#  level: DEBUG

uart:
  tx_pin: GPIO13  # Device dependent
  rx_pin: GPIO14  # Device dependent
  baud_rate: 500
  parity: EVEN

climate:
- platform: fujitsu_halcyon
  name: ${halcyon_name}
  # Fujitsu devices use 0 and 1, but 2-15 should also work. Must not skip addresses
  controller_address: 1  # 0=Primary, 1=Secondary
  #temperature_controller_address: 0  # Fujitsu controller address to read temperature from
  #temperature_sensor_id: my_temp_sensor  # ESPHome sensor to read temperature from
  #ignore_lock: true  # Ignore feature lock - not sure if this works

  # To capture communications for debugging / analysis
  # Use Wireshark with https://github.com/Omniflux/fujitsu-airstage-h-dissector
#  tzsp:
#    ip: 192.168.1.20
#    protocol: 255

Configure TZSP and use Wireshark with fujitsu-airstage-h-dissector to debug / decode the Fujitsu serial protocol.

Related projects

• FOSV's Fuji-Atom-Interface

• Aaron Zhang's esphome-fujitsu
• Jaroslaw Przybylowicz's fuji-iot
• Raal Goff's FujiHeatPump
• Raal Goff's FujiHK

• Myles Eftos's Reverse engineering