-
Notifications
You must be signed in to change notification settings - Fork 1.4k
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Why doesn't vtx catch a larger range of video signal? (pit) #10024
Comments
Hello, I have a vtx that does not want to catch a larger range, maximum 2 meters. And I know it would be on pit mode. vtx: tx805 I use the INAV system |
A VTX that only goes 2 meters means the channels don't match, or one of the antennas is broken / disconnected*, unless you're in pit mode. Check the instructions on your VTX and look at the LEDs to see a) if you're in pit mode and b) what channel you are on. Automatically scanning for the channel does not work unless you're 10-20 meters away, at least.
|
unfortunately pit mode doesn't work in INAV(see issue #8369) so you can't disable pit mode with INAV. |
do any of the 3 red, green or blue LEDs light up or flicker? I understood from the instructions that all of them are off when in pit mode. instructions say to press button for 12 seconds to exit pit mode. if that doesn't get it out of pit mode there might be something wrong with the VTX or something else. I'm not sure whether it helps but you can try disconnecting the SmartAudio wire and then pressing the button again. |
it did not work |
.
The text was updated successfully, but these errors were encountered: