Great project, could use better documentation #309
Replies: 4 comments 3 replies
-
Hey there, While pluggin in, I connected the housing of the ESP with Pin 4: While pluggin in, the green led is off. When I released my connection, the green led turned on.
Then I powercycled the device. The green led is now flashing; At this point I thought to see the Wifi, but there is no wifi. Thank you for your upcoming answer. :) |
Beta Was this translation helpful? Give feedback.
-
And do I need the resistor which is shown on this picture; |
Beta Was this translation helpful? Give feedback.
-
Okay guys, the config helps out: // Data of the Wifi access point |
Beta Was this translation helpful? Give feedback.
-
Why aren't you using something like esptool? |
Beta Was this translation helpful? Give feedback.
-
Hi! Great project. I managed to flash my ShineWifi-X to this custom firmware and everything works well. So thank you for that! :)
I think this project could benefit from improved instructions and documentation. Both for compiling your own version and for flashing to a ShineWifi-X.
In the neat future I will see if I can contribute to this project.
Beta Was this translation helpful? Give feedback.
All reactions