-
Notifications
You must be signed in to change notification settings - Fork 45
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
wd Reset #18
Comments
@Lucho1976 Regards. |
I already did it on myCAMSaveToSDFile function. Is this ok the place where i add the yield(), is this ok ? //Read JPEG data from FIFO |
@Lucho1976 //Close the file Regards, |
Hi Guys it work fine with 800x600 resolution but above that same problem. I added some more yield but the same thing. I have an arducam V2 and a OV2640 ( REV. B) 2MP I tried with memorysaver.h in this two configuracion and compile the whole project but wich one is the correct? : A) //Step 1: select the hardware platform, only one at a time //#define ARDUCAM_SHIELD_REVC //Step 2: Select one of the camera module, only one at a time
#endif B) //Step 1: select the hardware platform, only one at a time //#define ARDUCAM_SHIELD_REVC //Step 2: Select one of the camera module, only one at a time
#endif if you think i can try another thing or add some other yield in other section of the function i will appreciate so much. Regards |
Now is working with configure A) in OV2640_1280x1024 and it's fine to me. Thank you guys |
Again i got WDT reset, i add some serial.println and it fails just in this lines: outFile.write(buf, 256); i added 2, 4, 8 yield() but the same problem. i tried with A) and B) memorysaver.h above described but the same thing. When i use the /capture demo i can visualize perfectly the image but i can't write to SD card. The sd CARD is in FAT32, is that right ? Can you help me?... thank |
@Lucho1976 Let us know if you need more help. |
HI Guys when i set a resolution above 320x240 i get an wd reset arduino. Dou you know why?.
I have an OV2640 2 MP and running the V2_capture2sd example.
I get this error:
SD Card detected!
OV2640 detected.
Star Capture
Capture Done.
The fifo length is :67588
Soft WDT reset
ctx: cont
sp: 3ffef9d0 end: 3ffefe00 offset: 01b0
ets Jan 8 2013,rst cause:2, boot mode:(3,7)
load 0x4010f000, len 1264, room 16
tail 0
chksum 0x0f
csum 0x0f
~ld
The text was updated successfully, but these errors were encountered: